WAC Lighting EN-24100-RB2-T 120V Input 24V Output 100W Remote Enclosed Electronic Transformer for InvisiLED Tape Light, Black
About this item
- Soft start, short and overload circuit protection features. For use with WAC Lighting low Voltage under cabinet and recessed Lighting systems
- 1W minimum load to support low load LED systems. Intrinsically safe, class 2 Transformers permit no greater than a 5 amp current to be drawn
- Secondary wiring for class 2 Transformers does not require Conduit sheathed cable or clamp wiring techniques. Non-metallic sheathed cable may be used for secondary wiring in walls and ceilings
- Input Voltage: 120V AC, output Voltage: 24V AC, loads vary based on transformer 60Watt, 100Watt, 150Watt, and 300Watt
- Smooth and continuous dimming with an electronic low Voltage dimmer. Dimmers should always be installed on the primary side of the transformer. Standards: class 2, UL & CUL listed for Damp locations
- 6' lead wire with female connector is included
- 24V, 96W maximum load capacity - Requires a minimum load of 1W for consistent operation