Set of 4 Spark Plug Resistor Covers Kawasaki KZ650 KZ900 Suzuki GS550 GS750

Set of 4 new spark plug resistor covers replaces NGK's now discontinued VB05F and SB05F for many Kawasaki and Suzuki models from the late '70's. 

Rubber waterproof boots to seal out the elements, so the engine won't cut out if it rains.

For use with 7mm diameter plug wires

Installation tips:

Remove terminal nut before installing new spark plugs. It's screwed onto the top of the spark plug.
Put a light coating of anti-seize on the spark plug threading before installing. After all, you're threading a steel part into a aluminum engine case.
Don't over tighten the spark plug, 1/8 to 1/4 turn past finger tight.
When using the old spark plug wires, trim them back 1/4" - 1/2" to expose fresh wire, then using a pick type tool, fan out the wires before threading on the new resistor cover.
Twist on the new cover about 3 full turns and give it a tug to make sure it's snug.

Replaces NGK Part Numbers: 8032, 8080

Note: Some KZ1000 models with an electronic ignition have a ballast resistor which must be removed. Do research before ordering.