Rear Driveshaft For Jeep Grand Cherokee WK2 2011-2019 V6/V8 AWD/4WD 976-982

Fitment:

• 2011-2019 Jeep Grand Cherokee

Removing the drive shaft step by step:

• First, drain and collect the gear oil.
• Now remove the wheel.
• Loosen the locking screw.
• Loosen the ball joint and the tie rod end.
• Loosen the upper nut of the stabiliser link joint.
• Remove the ball joint of the front lower wishbone.
• Pull out the drive shaft.Thoroughly degrease all areas.
• Fit the new drive shaft.Reassemble all components in reverse order.
• Fill in new gear oil.

Matters to be checked after assembly:

• Check that the working rotating surface of the whole drive shaft shall not interfere with other parts
• Check the fasteners should be firm and reliable, no loose phenomenon
• Check that there is no leakage of each protective component

​Key Features:

• High-quality replacement Driveshaft
• This part may also be known as: Driveshaft Propeller Shaft Assembly
• 100% tested For reliability and performance.
• Top performance For long service life
• Internally Dampened For quiet performance.
• Added strength, no added weight.
• High Qaulity Steel construction softens shock to driveline components and tires.
• Improving traction and lessening breakage.
• Greased and ready to install
• High Speed Balanced

​Item Include:

• 1x Driveshaft Assembly

Note:

Please check the model and important parameters before purchase to avoid unnecessary after-sales problems, if you are not clear, please feel free to contact us, thank you for your cooperation!