Power Window Regulator for 2001-2007 Toyota Highlander Front RH Side w/ Motor

Description
 
      Our window regulator offer value without compromising quality. It with premium material and solid construction, ensures high strength and reliability. They direct fit -No missing holes, hardware or mounting brackets. It has been 100% tested for RPM, rotational direction, amperage and torque before shipment.

Highlights include
 

•    Built to meet or exceed original equipment performance

•    Simple electrical plug assembly, no wire splicing necessary

•    High-quality steel and plastic compounds for greater durability

Your "Right Part" Checklist

Use the compatibility chart to identify your vehicle.

Visually compare the part you are replacing with our pictures.

Match reference numbers from the Item specifics section above.

Find the year,make, model, engine and trim in vehicle application to ensure.

Part Number

Replaces dealer part number:748-610

Fitting for the following vehicles

2001-2007 Toyota Highlander Front Right

Package

1x Window regulator with Motor in a box

Install the window regulator as follows: 

Part1 Disconnecting the Window from the Motor

1.Remove the interior door panel.   

2.Gently remove the plastic door cover. 

3.Locate the window mounting bolts.  

4.Move the window if necessary to access the bolts. 

5.Remove the bolts while a friend supports the window.  

6.Raise the window up into the door frame. 

7.Use masking tape to secure the window in place. 

Part2 Disconnecting the Motor and Regulator

8.Remove the window regulator bolts.  

9.Locate and remove the window motor mounting bolts.

10.Disconnect the motor wiring harness connector.  

11.Remove the motor and regulator through the access port. 

12. Connect the regulator to the new motor. 

Part3 Installing a New Power Window Motor

13.Slide the new motor and regulator back into place.  

14.Replace the mounting bolts. 

15.Reconnect the electrical connector.   

16.Remove the masking tape and lower the window back down. 

17.Insert the window mounting bolts.   

18.Reinstall the plastic liner and interior panel.