- Lighten up your toolbox, this pocket sized calibrator replaces toolbox of single function devices.
- Icons on the display show you where to plug in test leads
- Technician friendly operation
- Can be used as a milliamp and voltage calibrator
- Simulate 2-Wire Transmitters
- Power up transmitters & loops with the built-in 24 V power supply
- Simplify HART hookups with built-in 250 Ohm resistor
- Calibrate directly in temperature (°C & °F)
- Source & read frequency to 2000 CPM (Counts-Per-Minute), 999.99Hz, 9999.9 Hz & to 20.000 kHz
- Troubleshoot loop & wiring problems
- 'Beep' out connections with the built-in continuity checker.
- Quickly set any three outputs plus automatic stepping & ramping
- Measure temperature sensors, frequency pickups, loop currents and voltage levels
- Check the values of your process sensors. Instantly recall MAX and MIN values to see process variability.
| Operating Temperature | -20 to 60°C (-5 to 140°F) |
| Storage Temperature | -30 to 60°C (-22 to 140°F) |
| Temperature Effect | ≤±0.005%/°C of Full Scale |
| Relative Humidity | 10% ≤RH ≤90% (0 to 35°C), Non-condensing 10% ≤RH≤ 70% (35 to 60°C), Non-condensing |
| Normal Mode Rejection | 50/60 Hz, 50 dB |
| Common Mode Rejection | 50/60 Hz, 120 dB |
| Noise | ≤±1/2 Least Significant Digit from 0.1 to 10 Hz |
| Protection Against Misconnection | Over-voltage protection to 60 vrms (rated for 30 seconds) Red LED indicates OVERLOAD or out of range conditions |
| Display | High contrast graphic backlit LCD with 0.315" (8.0mm) high digits |
| Power Supply | Four "AA" Alkaline 1.5V (LR6) |
| Battery Life | Read Functions: ≥ 20 hours; Source mA: ≥ 14 hours @ 12 mA into 250Ω Pwr/Meas mA: ≥ 12 hours at 20 mA; Source V, Ω, T/C, RTD & Hz: ≥ 20 hours |
| Low Battery | Indication with nominal 1 hour of operation left |
| Dimensions | 5.63 x 3.00 x 1.60", 143 x 76 x 41mm |
| Weight | 12.1oz, 0.34kg (including boot & batteries) |