*NEW FFT DESIGN*
Perfectly cut and rounded to transfer trigger pressure horizontally into the feed ramp, while preventing any sort of "catching" of the feed ramp for super smooth cycling and reset! No fitting, grinding, or frustration required! Replace your existing trip in seconds!
Stainless steel trips, to be used with Pembie's Trigger Shoes. May work in other models. You must disassemble your existing trigger assembly to install. Slide catch must be removed. Oil your gun for best results, especially the top of the barrel where it rubs the slide. Tested with 22lb recoil spring. WARNING this does NOT has a trigger safety.
OPTIMAL SETUP:
-20-22lb recoil spring (weak ammo might not cycle a 22lb spring)
-3.0lb Ghost Unit connector
-4lb striker spring (might get light strikes with hard primers)
-Lighter safety plunger spring
-Oil (top of barrel/underside of slide/slide rails)
-Polish trip where it touches the feed ramp
-Polish top of barrel/underside of slide
WARNINGS:
- By purchasing or using this product, you are accepting responsibility and liability for the serviceability of the final installation, as well as any damage or wear that may occur to your firearm.
- Improper installation or use of the FRT may lead to unintentional discharge of the firearm that may lead to injury or even death.
- We recommend installation be performed by a Professional Gunsmith.
- After the FRT has been properly installed, it is imperative that all users seek qualified training on how to use this product.