Oxford OFV8 Heated Grips Intelligent Replacement "V8" 5 Heat
Control Switch with Full Wiring
(Please Note Only The Wiring From the Control Unit is Supplied)
This item will fit the following Oxford hot-grip
sets :-
OF693 Original, OF694 Hot, OF695 Essential, OF696 Sport, OF698 Lights, OF690
Adventure, OF691 Touring, OF692 Premium Sports, OF771 Commuter & OF772
Scooter.
This item consists of the wiring loom to the battery & the fuse &
holder up to a 2 pin block connector just before the controller/switch unit,
and the actual V8 controller/switch which also includes a 2 pin block connector
to connect to the long loom (above) and the 2 x 2-pin plugs that feed the
actual heated-grips (basically just add your original grips and switch
bracket).
Standard features of the NEW V8 Switch/Controller unit.
Easy replacement for the earlier (V7/V7a) switch units (both switch
& loom need to be fitted to replace a V7/V7a unit).
Battery saving mode turns the grips off when you forget (so no need to
wire through the ignition).
Saving mode also turns off when idling and the battery voltage drops due
to high load.
Fits the original OF91 handlebar bracket if upgrading .
Battery saving mode can be enabled and disabled as required.
Raised & tactile Silicone buttons for use with gloved hands.
Rainproof switch unit sonically welded for total reliability.
Sealed for life one piece controller & switch assembly.
5 Different heat settings for total comfort.
Grips can heat up to 50c.
Draws under 4 amps.
Easy to fit and wire up :-
NEW 2-part loom is easier to run (no pesky controller to feed through
the chassis)
Grips and main loom simply 'Plug' into the controller wiring.
Only 2 connections to the battery required.
You are buying the Replacement V8 switch/control box and wiring loom as
per the above picture Only. No other parts of the kit are included in this listing