Makita Bit Piece ADAPTER
A-44672
From Japan
Description
It is a part to fill the shank gap when using other than genuine Makita bits.
Applicable models: All impact driver models
Use the following bits and sockets. Otherwise, do not use it.
A = 17mm
B = 14mm
Bit piece (sold separately) is not required.
(* Genuine products are all this size.)
-----------------------
A = 12mm
B = 9mm
Bits of this size are shown below
Use bit pieces.
To install the bit, insert the sleeve
Insert the pulling bit in the marked direction and
let go of reeves.
The bit cannot be pulled out even if it is pulled lightly.
Please confirm that.
When using bit pieces,
Pull the leaf in the direction of the arrow to
Insert in the order of the slot and bit, and
release the button.
When removing, pull the sleeve to remove the bit.For commercially available products (A = 12 mm, B = 9 mm), fully insert the bit piece and bit in this order.
Firmly insert the bit as far as it will go. If it is insufficient, the sleeve will not return to its original position and the bit cannot be fixed.