LEFT HAND HANDLEBAR CONTROL SWITCH W/LEVER TURN SIGNAL AND HORN BUTTON

FITS CT90 CL90 S90 ST90 SL90 BIKES

--------------------------------------------------------------------------------

THE LEFT SIDE TURN SIGNAL WIRES WILL BE ALL THE SAME AS YOUR ORIGINAL SWITCH.

1. LIGHT BLUE TO LIGHT BLUE

2. ORANGE TO ORANGE

3. GREY TO GREY

4. AND HORN LIGHT GREEN TO LIGHT GREEN

------------------------------------------------------------------------------

SWITCH HAS A PEG STICKING UP TO GO INTO A HOLE IN THE HANDLEBARS. IF YOUR BARS DON'T HAVE THE GUIDE HOLE FOR THIS THEN YOU WILL JUST NEED TO CUT OR BREAK IT OFF.

       WHEN TIGHTENING THE 2 SCREWS ON THE SWITCH BODYS BE SURE TO TIGHTEN THE FRONT SIDE UP ALL THE WAY THEN TIGHTEN THE BACK MOST SCREW. THERE WILL BE A GAP TO THE REAR OF THE SWITCH, WHICH IS CORRECT HONDA PROTOCOL.  IT PINCHES THE BAR AND KEEPS WATER OUT FROM THE FRONT.

COMES WITH 10MM MIRROR HOLES  (: THEY WORK BETTER! THAN THE 8MM.

    IF YOU WANT THE WIRES ON THE OUT SIDE OF THE HANDLE BARS YOU CAN MAKE A NOTCH LIKE THE LAST  PICTURE SHOWS.