Land Rover 200/300 tdi cooling fan support bearing.
This bearing is new but derived from another use . I import this bearing and modify it to replace the fan support bearing , when fitted it protrudes approximately 9mm to the rear of the casing ,see picture ,this does not interfere with anything .
To fit this bearing you will need the expert use of a hydraulic press and an oven or heat gun to warm the casing ,nearly too hot to handle .
Its a through bore in the casing so will press out from the front with a half inch thick bolt allowing the pulley flange to pop off the shaft ,so no broken flanges .The new bearing fitted flush to the front face of the casing has a shoulder flange to the front shaft that when fitted places the pulley correctly for belt alignment and bolt clearance so no problems there, see picture
Thanks for looking .
NB. New fan flanges are also available made in the round from billet bright steel, see other items.New batch price reduction.