Features:
Self-healing,Stretchable, Scratch Resistan Item.
Easy Removal with No Residual.
Suitable for Any Headlights, Fog Lights, Side Marker lights or Even Top Part of the Windshield, etc(DIY)
Name:Light control color changing headlight film
Material :TPU
Color: transparent to black, transparent to purple
Size:Width:30cm/40cm/50cm Length:1M/2M/3M
（Suitable size of general car headlights: 1.5m. If your car headlight size is too long, please select 2 meters.）
Important Reminder:
About TPU Soft Film:
1. The TPU soft film is washable and can be installed multiple times.
2. Spray water or detergent water on the film and screen to help squeeze out bubbles.
3. The soft film can be installed many times without damage. If installed failed, just removed it and installed it again until successful.
4.TPU is one kind of rubber and it is elastic, if it is folded, the crease will disappear when it stick on the car. Unless there is a hole, the folded will not affect the installation.
The screen must be cleaned before installation and ensure that there is no dust.
If you are not good at DIY, it is best to ask local professional installers for help. But if you don't find it troublesome, you can install it yourself, but there may be a lot of bubbles after installation, you need to try repeatedly until the bubbles are removed and the installation is successful. We will not accept the refund for manmade mistakes or due to wrong installation.
*This TPU Photochromic PPF Will only turn color when there is UV,the stronger the UV is the darker the color will be,the color will be Smoked black/Smoked purple,when UV is weak the color will back to transparent.
*The main function we designed this PPF is to protect the car headlight from scratch/ damage,the photochromic is an add value bounus function,the photochromic function will fade by time normally last for max 12months depends on how you take care of the PPF.
*Due to the difference between different monitors, the pictures may not reflect the actual color of the item.
Installation Tip :
Step1:prepare the spary bottle (water and 1 drop of shower gel),rag and scraper ,to totally clean the application area.
Step2:remove the film and spray it with a certain amount of water on the sticky side .
Step3:Align the holes first which will help to align the whole piece film.
Step4:Scrape the water and air bubbles out from center to corner by using a scraper.
Step5:Use a heat gun,hair dryer,or lighter to flatten and affix the uneven place.
