***Check my feedback for the positive reviews of this product***
Offered for sale is this improved Ohme Home Charger cable holder.
This replaces the really substandard and weak Ohme cable holder (shown in photos 8, 9 & 10) which fails after a few days and Ohme will not replace.
This uprated unit has been bespoke designed and 3D printed out of far stronger PLA to ensure it lasts. Is much thicker than the original Ohme unit and also has reinforcement to the edges to prevent it from bending.
Note the picture is of my own Ohme Home Pro Charging Unit with this uprated bracket and 8 meters of cable.
NB: This is for the back plate that holds the cable, the plug connector is reused with no alteration being made and fits in to the existing 4 x screw holes in your wall - a direct replacement, and a 5 minute easy DIY job.
The image showing the connection section is purely for reference/show. This does not include the female socket with locking button that the charger plugs in to.
Fitting is easy - Simply remove the four screws holding the existing socket and cable organiser in place and replace the sagging cable organiser with the new improved version
The item will be despatched within 48 hours of receiving payment.
Any questions please contact through eBay messages.
Installation Instructions (5 minutes)
1. Get a Phillips screwdriver and remove the 4 screws to release existing socket and backplate
2. Change the old backplate for this new improved backplate.
3. Place the 4 screws back through the socket and backplate to secure back to the wall.