Brand New Kit Magneto Flywheel + Stator

Direct replacement to your original units

Plug-and-play, direct fit, easy installation

Connector, pick up pulsar coil, rubber grommet included

All products shipped are tested

Brand new Kit Magneto Flywheel + Stator

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation
• All shipped products are tested
Brand new stator
• Highest grade of lamination materials
• Highest grade of copper winding, resistant to 200 degrees Celsius
• Connector, pick up pulsar coil, rubber grommet included

Magneto Flywheel Rotor

Brand new Magneto Flywheel Rotor

• All products shipped are tested

All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part

Yamaha YFS 200 Blaster -- 1988-2006

107872-R00

Stator

Dimensions:
Interior diameter: 27 mm
Exterior diameter: 79 mm
Thickness: 13 mm
Length of wires stator to grommet: 80 mm
Length of wires grommet to plug: 450 mm

Other specifications:
Number of wires: 5
Number of plugs: 5
Number of pins: 5
Number of poles: 2
Wire to wire resistance:
Alternator: Yellow/Red to Black = 0.6 ohms +-20%
Black Wire is Grounded
Pickup: White/Red to Black = 24 ohms +-20%
Source: Black/Red to Green/White = 230 ohms +-20%

Magneto Flywheel Rotor

Dimensions:
Exterior Diameter: 118 mm
Interior Diameter: 84.5 mm
Interior Diameter Center Housing: 19 mm
Exterior Diameter Center Housing: 26 mm
Thickness (exterior): 45 mm
Thickness (interior): 40 mm

Before attempting to start your Yamaha, adjusting the air gap is necessary. Rotate the flywheel so the raised node is lined up with the pick up/pulser coil and adjust as close as possible but no less than 0.010".

Before installing your new Stator

• Check the AC output of the stator
• Replace any burned or corroded connectors on stator and regulator rectifier
• Check and repair any melted wiring
• Use hi-temp dielectric grease on all connectors

Our stator might have a different wire color code than your original part.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible but no less than 0.010".

Warning:

Risk of electric shock. Disconnect the battery before servicing.
Ensure proper installation by a qualified technician to avoid malfunction.

Our multiple North American locations, from which we ship our products, allows us to deliver 99.7% of our orders within the specified time period. If your item is not available in our main Colorado facility, we still guarantee that your order will be delivered within the specified time period.

If your item is not delivered within this time period, we will offer you a 5.00$ discount on your order. This guarantee applies to shipments delivered in the 48 continental USA states, excluding PO boxes.