vintage 1970s New Old Stock TDK fasel style inductor for true 70s style wah sounds. key components modded for that sweet, throaty, watery tone that growls when pushed.
features:
-full dunlop vox PCB, modded at the Joe Gagan Shop.
- actual 70s TDK fasel inductor for great 60s harmonics and tone
- vintage thomas "5117" transistors specially selected for low gain and vintage response. may differ from photos, but all are OLD stock low gain high quality selected for proper vintage tone ( modern transistors do not sound as good !)
-special orange drop and other caps and circuit mods, joe gagan's special recipe, developed from modding and designing thousands of wah pedals.
-input volume trimmer for volume matching and HOTrodded wah tones! allows tailoring to single coils, humbuckers, or other pedals in your chain.
- HOTrod gain mod -- first transistor gain is jacked up for more touch response for clean to dirty at your fingertips -- touch reactive!
| just change out the PCB with 2 screws and quick connect, solder in the new pot and adjust, bam! you're done. -fits all US made vox wahs with terminal clip, 1992 thru 2005- says "MADE in USA " on bottom. DOES NOT FIT CHINESE V847A or V845 models. DOES NOT FIT CRYBABY wahs |
features:
-full dunlop vox PCB, modded at the Joe Gagan Shop.
- actual 70s TDK fasel inductor for great 60s harmonics and tone
- vintage thomas "5117" transistors specially selected for low gain and vintage response. may differ from photos, but all are OLD stock low gain high quality selected for proper vintage tone ( modern transistors do not sound as good !)
-special orange drop and other caps and circuit mods, joe gagan's special recipe, developed from modding and designing thousands of wah pedals.
-input volume trimmer for volume matching and HOTrodded wah tones! allows tailoring to single coils, humbuckers, or other pedals in your chain.
- HOTrod gain mod -- first transistor gain is jacked up for more touch response for clean to dirty at your fingertips -- touch reactive!
INSTALL INSTRUCTION -- remove your PCB , cut the battery clip from your harness ( no longer needed), plug in harness clip to NEW PCB, rescrew the screws. remove and replace pot, colors-- BLACK to rear lug, yellow to middle, Blue to toe end of pot lugs.
NOTE! your PCB may vary slightly from photos for quality improvements. parts availability may vary, but we never lower our parts quality.