Selling Point:
1) Good light type, Low power consumption and super bright lighting,the position of the light-emitting point is 1:1 to the original car halogen lamp.
2) No delay to light up, Faster on/off response time, low power consumption and high lighting,Good Quality And Durable,Easy to Install,Good Feel.
3) Lifespan: Up to 50,000 hours working hours, stable quality, long service life, adopt imported chips emit 360 degree light can light up every corner.
4) The model is as the same as factory light, no need to change car wire rute, for most cars, just Plug and Play, NO modification required A direct replacement part that easy to install.
5) With High-purity brightness, strong penetrability and superior stability,Energy saving, environmental protection, through strict test, Use safer driving in the car,highly recommended.
6) Anti-electromagnetic interference.
light Source Model: LED Chip, 4-sides leds, super bright
Power: 100w/Set & 50w/bulb
Lumen: 10000LM/Set & 5000LM/bulb
Operating voltage: DC9-30V
Beam Type: High beam & Low beam
Material: Aluminum PCB and PA66+30% GF Plastic
Beam Angle: 360°
Color Temperature: 6000K-6500K Cool White
Lifespan: over 50000h
Working Temperature: -40-+80 Centigrade
Waterproof rate: IP 68
Plug for this listing: H4/HB2/9003 Plug High Low Beam LED Headlight Bulbs Kit
Connector Type: Plug and Play
Application: LED Headlights Headlamp Lamp Bulbs High or Low Beam
Package include:
2x H4 LED Headlight
Attention:
LED bulb is low power device, the following issues may occur if you want to use LED bulb on some European vehicles: Hyper Flashing, No Flashing, or Error Code. Those are NOT problems of LED bulb and NOT covered by warranty. You may simply add a set of load resistor (NOT included) to avoid those issues.can be solved with a decoder (decoder must be purchased separately)
If the bulbs don't light up, please rotate the bulb 180° and then install.
Install Caution:
1. As a safety precaution, make sure that the car has had time to cool down properly before starting the installation process.
2. Put the vehicle into park or make sure it is securely in gear.
3. Make sure to have the ignition turned off and the keys removed.
4. Be careful to avoid burns, especially when turning on or off the vehicles lighting.
5. Be careful to avoid crushing or cutting the bulbs. Also make sure to not touch the bulbs with your fingers, as this will cause blotting.
6. Fully examine the connection of the contact points, ports and the wires as faulty connections can cause lighting problems.
7. Make certain that the end of the bulb does not come in contact with the interior light shield of the headlight when adjusting the bulb.