General Information
The KBET-240D is designed to accept a pulse input, which is produced by most "open collector" (Hall, magnetic, inductive and opto) or 2-wire inductive pickup, and create two independent isolated output signals. The Tachometer Output is normally used for tachometer feedback. The Follower Output is used to drive a second control in a master/slave system. If tachometer feedback is not required on the master motor, the Tachometer Output can be used to drive an additional slave.
Two LED Indicators are incorporated into the KBET circuitry. The "Power On" LED is used to indicate that the unit has AC power, and the "Pulse" LED is used as a diagnostic to verify the presence of an encoder input.
Jumper selections allow for setting the AC line input voltage (120/240VAC) and the sensor type. The KBET is factory calibrated to 7V/1000 RPM (sensor type-60 pulses/rev) for the Tachometer Output and 10VDC per 1800 RPM for the Follower Output. Multiturn trimpots are provided to tailor the Tachometer and Follower Outputs for specific applications.
There is a downloadable manual online
Item has not been installed
Should be installed by qualified technician
All items are checked for damage, chips, cracks, or any other issues. If there are any issues on the item, it will be noted below, in the description above or shown in photos.
Items that are used may need a little extra detail cleaning.
Please don't hesitate to contact us before or after receiving the item.
We do combine shipping when possible. Please read the full description and look at all photos before buying.