Double Tape Measure Holder
This holds two Tape Measures at a 10-degree angle and is designed to work with many 25' tape measures, including wide versions (such as Stanley FatMax). For each tape measure, the maximum width is 1.9" (49mm) but they also has a notched slot to hold tape measures that are 1.5" (39mm) wide as well. For reference, see photos for a variety of tape measures it can hold. Smaller or skinnier tape measures may not be held well. The sides are mostly open and there's a wide gap between the 2 locations to allow for belt clips to not interfere. There is a vertical slot in the back to hold a pencil or sharpie marker behind the tape measures. The back is designed to mounted in a variety of ways including screws to the wall, pegboard* with holes at 1" on center, and Ryobi Link Wall Rails.
If mounting to the wall with screws or Ryobi Link Wall Rails, pegs stay recessed on the back and are not used. If mounting on pegboard*, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes. We recommend you superglue them into place. 2 extra pegs (one curved & one straight) are included. If mounting to the Ryobi Link Wall Rails, it can be used with or without an additional screw (not included) to hold it into place more securely.
No tape measures are included. Tape Measures shown in photos are for reference purposes only.
* Note that there are many different types of pegboard and some may not work. This was designed to work on 3/16" thick masonite pegboard with holes at 1" (25.4mm) on center only.
It is 3D-printed in PLA plastic. It is 4.7" x 4" x 3.5" (118mm x 103mm x 90mm).