Description
A must-have photo tool for orthodontists
Assisted use of photography for doctor-patient communication
Intraoral automatic defogging
With LED light to enhance the light inside the mouth
Lens double-sided 12K mirror state
The mirror surface is flat and not deformed, and the image is not distorted
The mirror surface has no surface quality defects such as scratches, pits, pits, and drapes.
|
Name
|
Fog free photo
mirror
|
|
Number of mirror
|
4 pieces
|
|
Material of
mirror
|
high hardness
stainless steel
|
|
Packing Size
|
151mm * 93mm *
45mm
|
|
Net Weight
|
150g
|
|
Battery
|
1000mA, 3.7V
|
|
Input
|
5.0V, 1000mA
|
|
Out put
|
Max. 1.3W
|
|
Surface
Technique
|
12K X 2B surface
|
MIRROR SIZE:
|
Occlusal L
mirror
|
142 * 68mm
|
|
Occlusal M
mirror
|
140 * 53mm
|
|
Buccal mirror
|
146 * 50mm
|
|
Lingual mirror
|
152 * 41mm
|
1.Introduction
Reflectors, matching action of three ifferet reflector.It is made of 8K mirror 304 stainless steel material, stamping process and highly polished finish.The reflector is uniquely designed by experienced clinical experts, and the turning angle distance at the back has been repeatedly demonstrated.It conforms to the Asian's design, and can fully open the soft tissues of the cheeks at the back of the mouth, so that the joints can be photographed completely and clearly.The reflector is connected to the host with a plug-in design.The main unit has the functions of blowing and defogging and light-assisted focusing, so that the reflecting plate into the mouth, not because of the temperature.At the same time, there arem, enough LED light sources to allow the photography equipment to successfully focus.
2.Host parameters
1t is powered by a lithium battery, and the charging voltage is 5v. Charging, red, full, green light, the charging time is about 2-3 hours.
3.Description of the buttons on the main unit
The left button of the main unit is the air blowing and LED light source switch, lightly press to turn on the air blowing and LED light source, press again to turn off the air blowing and light source, the right button is the ai blowing switch. lightly press to turn on the air blowing, and then Click to turn off blowing
4.Usage and precautions
Use the pull hook to pull the opening corner. The reflector is placed on the pin position of the host.
Turn on the blower and light buttons.
The reflector rotates into the mouth.
Pay attention to the position of the reflector, don't lift up and touch the teeth to bephotographed.
The shooting is completed when the subject's mouth is at its maximum.
The host will automatically shut down after working for 2 minutes. The purpose is to prevent the lights from overheating and reduce battery consumption.
