DC 5-30V Non-Contact Liquid Level Sensor Water Alarm Induction Switch Detector

Slide Slide Slide Slide Slide Slide Slide Slide Slide Slide
$8.98
Brand
Unbranded
Current Type
DC
Termination Type
Cable
Sensor Type
Electromechanical
Country/Region of Manufacture
China
condition
New
                                                DC 5-30V Non-Contact Liquid Level Sensor Water Alarm Induction Switch Detector

Parameter
  1. Input voltage: DC 5-30V
  2. Response time: 500Ms
  3. Level Error: ±1.5mm
  4. Wire length: 1.2m(47 inches)
  5. Humidity: 5% ~ 100%
  6. Material: ABS
  7. Waterproof level: IP65
  8. Operating temperature: -5℃ ~ 105℃ 
  9. Wiring:  Brown=power "+"   ,  Blue=power "-"   ,  Black=signal   ,   White="NPN normally open"(when hang up) or "NPN normally closed"(when white and blue wires connected together)
Sensor sensitivity adjustment
  1. Counterclockwise adjustment increases the sensing distance, and clockwise adjustment decreases the distance
  2. The sensor can sense human hands, so it is recommended to adjust the sensor after installing it in a fixed position to avoid human hands appearing in the sensing range
Measuring output voltage
   The sensor is NPN normally open output , collector open output, when no load is connected and only a multimeter is used for measurement, the high level value is virtual electricity and has no practical significance.
    The sensor should be connected to a load less than 0.2A(alarm light , small relay,pull-up resistor, optocoupler...etc...), then use a multimeter to measure the output terminal, and the data will be valid.


"Normal Open": Output signal when liquid is detected   ;  "Normal Closed": Output signal when no liquid is detected
© 2025 Dreampools solar