Comtech EF Data CDM-625 Advanced Satellite Modem
The CDM-625 Advanced Satellite Modem builds on our legacy of providing
the most efficient satellite modems. It was our first modem to combine
advanced Forward Error Correction (FEC) such as VersaFEC and Low
Density Parity Check (LDPC) codes with the revolutionary DoubleTalk Carrier-in-Carrier bandwidth compression, allowing for maximum savings
under all conditions.
This combination of advanced technologies enables
multi-dimensional optimization, allowing satellite communications users to:
• Minimize operating expenses (OPEX)
• Maximize throughput without using additional transponder resources
• Maximize availability (margin) without using additional transponder
resources
• Minimize capital expenses (CAPEX) by allowing a smaller BUC/HPA
and/or antenna
• Or, a combination to meet specific business needs
Typical Users:
• Mobile Network Operators
• Telecom Operators
• Satellite Service Providers
• Government & Military
• Enterprise
• Offshore
Common Applications:
• Mobile Backhaul
• G.703 Trunking
• IP Trunking
• Offshore & Maritime Communications
• Enterprise
• Communications on-the-Move
• Satellite News Gathering
Features:
• DoubleTalk Carrier-in-Carrier bandwidth compression
• Carrier-in-Carrier Automatic Power Control
• Adaptive Coding and Modulation (ACM)
• Packet Processor with header compression, payload
compression, advanced Quality of Service (QoS) & Managed Switch Mode
• 4-port managed Ethernet switch with VLAN and QoS
• Jumbo frame support
• Dual Band Capability: 70/140 MHz and L-Band in same unit,
extended L-Band receive
• Data Rate: 18 kbps to 25 Mbps
• Symbol Rate: 18 ksps to 12.5 Msps
• Modulation: BPSK, QPSK/OQPSK, 8PSK/8-QAM, 16-QAM
• FEC: Viterbi, Sequential, Concatenated Reed Solomon, TCM,
Turbo Product Code (TPC) (IESS-315 Compliant), LDPC Code
and VersaFEC (low-latency LDPC)
• Widest Range of data interfaces: EIA-422/530, V.35, G.703 T1,
G.703 E1, G.703 T2, G.703 E2, Quad G.703 E1, ASI, LVDS,
HSSI, 4-port 10/100Base-T Ethernet
• IEEE 1588v2 Precision Time Protocol
• Sub Mux to multiplex IP/Ethernet traffic with serial or G.703
traffic
• Drop & insert for T1/E1
• Enhanced D&I++ for single T1/E1 & quad E1
• Management: 10/100Base-T Ethernet with SNMP, Distant
End SNMP Proxy, HTTP, Telnet and EIA-232/EIA-485
• Carrier ID using MetaCarrier® Technology
• Embedded Distant-end Monitor and Control (EDMAC)
• Automatic Uplink Power Control (AUPC)
• Engineering Service Channel (ESC/ESC++)
• Standard high-stability internal reference
(± 6 x 10-8
)
• 5-tap Adaptive Equalizer
• L-Band TX: 10 MHz reference for BUC, FSK communications
and optional BUC power supply
• L-Band: Advanced FSK for LPOD M&C
• L-Band RX: 10 MHz reference and LNB power supply
• Open network modes
• 1:1 and 1:10 redundancy switches available