Compression Sleeve Puller Tool Remove Nut & Ferrule of Pipe 03943- Sleeve Remove

Compression Sleeve Puller Tool Remove Nut & Ferrule of Pipe 03943- Sleeve Remove

• Saves A Lot Of Time-- if you don't have sufficient exposed copper to cut off the old compression fitting, this angle stop puller will effortlessly remove the old compression ring and reform the previously crimped copper pipe back to a perfect circle. Saves a lot of time around cutting old pipes.
• Make Your Life Easy--This sleeve remover removes 1/2-inch copper water compression sleeve.This compression sleeve puller removes leaking compression sleeves without damaging walls, which effortlessly pulls the nut and ferral off of the pipe.
• Operating Steps--1.Remove the old compression fitting or the old angle stop. 2.Put the nut of pipe to the golden threaded mouth of the puller tool to tighten the screw 3.Make sure the ferrule puller is properly aligned with the pipe, and then you are able to remove the nut and ferrule with maybe 10 turns of the handle. 4.The puller tool will automatically pull compression nut and ferrule.
• Resistant & Wear Resistant.--Even such as the existing supply stops are severely corroded or frozen, you can turn the lever to extract the old compression sleeve from the pipe.Ideal for working on frozen or corroded supply stops,corrosion resistant & wear resistant.

0.5 inches x 5.5 inches x 7.5 inches. Weight: 9.7 oz