CLEAR-SEAL 100% Urethane Low Gloss Super Premium Sealer
Clear-Seal 100% Urethane Low Gloss Super Premium Sealer
Rainguard Clear-Seal™ 100% Urethane is an exceptionally tough, durable and breathable low gloss sealer. This product creates a hard low gloss film that is more UV resistant, stain resistant, and hot tire resistant than that of Clear-Seal™ acrylic urethane blended sealer. It provides a nice looking finish for concrete, stone, masonry, unglazed tile and wood surfaces. It is a water based, low VOC, single-component, self cross-linking clear urethane water based sealer.
Clear-seal is available in both a Low gloss and High Gloss formula in 1 gallon and 5 gallon containers. For optimal results, add Urethane Quick Cure Performance Additive.
Clear-Seal is designed to increase chemical resistance, impact resistance, chip resistance, added UV protection and better absorption of the Clear-Seal. Urethane Quick Cure Performance Additive mixes easily. Add 2 oz of Urethane Quick Cure per gallon of Clear-Seal™ 100% Urethane (select this option under the Performance Additive dropdown). Mix for 5-10 minutes. Adding Urethane Quick Cure gives the solution a 72-hour pot life. Extend pot life by adding more Urethane Quick Cure if needed.
Where is Clear-seal Low Gloss used?
- Construction & Remodel Projects: Commercial floors subject to heavy foot traffic, walkways, protection of outdoor and indoor painted wall murals
- Homeowner projects: Driveways, garage floors, decks, patios, porches, walkways, fences
Why Clear-Seal Low Gloss Sealer?
- Excellent Impact and wear resistant
- Resists hot tire pick-up for vehicular applications
- Performance Additive Available for Even Better Performance
- Excellent Chemical and Stain Resistance
- Resists UV rays - won't yellow
- Excellent adhesion
- UV protectant
- Anti-Slip Finish Available
- Interior/Exterior Protection for Concrete, Brick, Pavers, Stone, Unglazed Tile and Wood
- Specified by architects in CSI Division: 099123, 099723, 099313
TECHNICAL INFORMATION |
|
|---|---|
| Color | Clear |
| Sheen/Gloss Level | Low gloss |
| Re-Coat Time | When completely dry, 4-6 hours typical. Do not wait longer than 24 hours before applying a 2nd coat. If you do, sand surface with 100-150 grit sandpaper, remove debris, wipe with acetone just before application |
| #Coats Recommended | 1 – 2 coats depending on level of protection desired |
| Back in-service time | 24 hours to walk-on and 72 hours to drive-on |
| Application method | Spray, brush or roll (1/4″-3/8″ nap non-shed, water resistant) application. Sprayer requires use of heavy-duty acetone pump sprayer (ie; Chapin Xtreme) or pesticide sprayer (ie Hudson, Ortho) with low volume fan tip |
| Where Can it be Used | All Interior|Exterior architectural surfaces |
| Apply to New Concrete | 28 days |
| Application Temperature | 50F|10C up to 90F|32C Surface & Air temperature |
| Base | Water |
| VOC Content | <50 g/L |
| Use on Material | All masonry, concrete, paver, stone, unglazed tile and wood surfaces |
| Odor | Slight Latex Smell |
| Viscosity @77F (Brookfield) | 50-100 cps |
| Direct Impact | 140 inch-lbs |
| Reverse Impact | 40 inch-lbs |
| Pencil Hardness | 2H |
| Taber Abrasion, CS 17 Wheel, 5 to 7 Days | 8.4 mg loss |
| CHEMICAL TEST DATA | |
|---|---|
| IPA | No Effect |
| MEK | No Effect |
| Toluene | No Effect |
| 50% Sodium Hydroxide | No Effect |
| 50% Phosphoric Acid | No Effect |
| 50% Sulfuric Acid | Stain Only |
| 37% Hydrochloric Acid | Stain Only |
| 100% Acetic Acid | Failure |
| COVERAGE RATE | SQUARE FEET/GALLON |
|---|---|
| Porous Surfaces | 250-300 |
| Dense Surfaces | 300-350 |
| *Textured surfaces | Decreases coverage rates |
| Size | Performance Additive | Price |
|---|---|---|
| 5 Gallons | With Quick Cure & Performance Additive | $1,022.35 |
| 1 Gallon | With Quick Cure & Performance Additive | $224.25 |
| 5 Gallons | No Performance Additive | $921.15 |
| 1 Gallon | No Performance Additive | $202.40 |
Shipping
Shipping cost:
No cost shipping lower 48 US States FedEx Ground
Delivery time:
Typically 3-5 days to process order plus 1 to 5 days transit time after shipment depending on location
Payment
We accept the following payment methods:
- PayPal payment due at time of order placement
Please contact us if you have any questions.
Service
PLEASE CONTACT CUSTOMER SERVICE FOR QUESTIONS