Black EV Cable Male Plug Electric Car Charger 32A 1P Single Phase Type 2 EU IEC62196-2
- please read before ordering:
- Male Plug goes to Charging Station and Female Plug goes to Car
- please check before ordering what exactly you need !
- knowledge and skills to install this Plug required
This listing is for:
- Black Color
- New Type 2 Male Plug
- 240V 1 Phase
- IEC 62196-2 Standard
- approx. size 220x70x65mm
- will be packed and posted via courier
Instructions:
16A: 680 Ohm resistor is wired from pin PP to centre pin PE (earth) on each plug at both ends of the cable. The purpose of it is to signal to the charger and car that the plugs are inserted. The resistance should measure 680 Ohm at each end across pins PP to PE and therefore 1360 Ohms between the two PP pins from one end to the other end of the cable. All other pins should read zero Ohms from end to end.
32A: 220 Ohm resistor is wired from pin PP to centre pin PE (earth) on each plug at both ends of the cable. The purpose of it is to signal to the charger and car that the plugs are inserted. The resistance should measure 220 Ohm at each end across pins PP to PE and therefore 440 Ohms between the two PP pins from one end to the other end of the cable. All other pins should read zero Ohms from end to end.