DESCRIPTION
The Glock slide firing pin channel has a part installed in it which is called the channel liner. The channel liner is a tubular shaped plastic part that is pushed into the channel with a special tool and stays in place by way of friction fit. The purpose of the channel liner is to lessen the firing pin spring and spring cup wear and to eliminate the need for lubricant. The liner needs to be removed and replaced with a new one if it gets scored, heavily scratched or when the slide is going to be refinished in an extremely hot environment such as reblueing in a hot tank or when curing finishes in an oven.
The channel liner tool is designed to both remove and install the channel liner in the Glock slide without damaging the slide. (TOOL IS NOT NECESSARY TO INSTALL THE STAINLEES STEEL CHANNEL LINER)
The channel liner tool is designed to both remove and install the channel liner in the Glock slide without damaging the slide. (TOOL IS NOT NECESSARY TO INSTALL THE STAINLEES STEEL CHANNEL LINER)
To remove the channel liner, simply screw the threaded end of the tool into the liner, insert a Glock tool into the hole on the tool and pull the old liner out.
To install a new channel liner, place the liner on the unthreaded end of the tool and push the liner into the channel as far as it will go by hand, then lightly tap the end of the tool with a plastic, wood or brass hammer until it fully seats into the channel.
Made from stainless steel
MADE IN USA
Also incudes -Stainless Steel Firing Pin Channel Liner
Low Friction Stainless Steel Channel Liner- Fits All Models
The Stainless Steel Channel Liner fits (GEN 1-5) Glock models 17, 17L, 18, 19, 19X, 20, 21, 22, 23, 24, 26, 27, 29, 30, 31, 32, 33, 34, 35, 36, 37, 38, 39, 40, 41, 45, 47,
The Low Friction Stainless Steel Channel Liner is a new product. One of the problems with trigger kits for Glock Pistols is the issue of light primer strikes with reduced powered striker springs. The Stainless Steel channel liner reduces the friction between the channel liner and the firing pin assembly which allows for more reliability with reduced power springs.Less friction to help increase Firing Pin speed-Allows for the use of reduced firing pin springs with a major reduction in light primer strikes
-Removable without any tools for easy cleaning/maintenance
-Low friction Stainless Steel allows for a lifetime of use
-Much less fragile than OEM channel liners
-The more it is used the less friction there will be
Disclaimer - "GLOCK" is a federally registered trademark of Glock, Inc. or Glock Ges.m.b.H. GoTo GEAR has NO affiliation in any manner with, or otherwise endorsed by, Glock, Inc. or Glock Ges.m.b.H. The use of the word "GLOCK " on this page is merely to identify which firearm these parts or components are compatible with.