300bar / 4500PSI Air Compressor High Pressure Electric Air Pump for Air Gun 110V
Description:
This product is compact, compact and portable, temperature display, high-pressure exhauster integrated design; Battery driven, fast and fuel saving; The operating temperature of the machine is displayed, and the temperature of the machine is monitored in real time; Built in cooling fan, large area hollow shell, effective heat dissipation; The fuselage is equipped with a high hardness plastic handle, which is light and easy to carry; Easy to filter and maintain.
Specifications:
- Voltage: 110 V / 60 HZ
- Power: 300 W
- Power Supply: 12V Car Battery ( 30 + A )
- Working pressure: 0-30 Mpa
- Maximum Pressure: 300bar / 4500psi / 30mpa
- Oil-water filter: Exist
- Cooling System: Two High-power Fans
- Oil or Water: Neither Need
- Shut Off: Manually
- Product size: 21.5 * 17.2 *13.2 cm
- Packing size: 35 * 30 * 25 cm
- Product weight: 5.2 KG
- Packing weight: 7 KG
- Applications: suitable for most PCP air guns and paintball HPA tanks
- Filling speed: 0.5L, 0 to 300bars, needs 20 minutes around. 200-300bars, needs 8 minutes around
Features:
- Compact structure: compact and portable, temperature display, integrated design of high pressure air pumping machine.
- Battery drive: 12 power for vehicle use, 30MPa fast gas saving and convenient.
- Temperature digital display: machine running temperature display, real-time monitoring of machine temperature.
- Manual shutdown: the power on and off buttons are configured on the side of the fuselage, which is simple and easy to operate.
- Efficient heat dissipation: built in cooling fan with large area hollow shell, effective cooling.
- Portable handle: the body is equipped with high hardness plastic handle, lightweight design, easy to carry.
- Easy filtration: with external oil-water separation filter, easy maintenance.
Use Steps :
1 . Check the 110V AC voltage set on the converter
2 . Connect the power and air hose
3 . Turn on the cooling fan
4 . Tighten the bleed valve to the right
5 . Start the compressor
NOTES :
The inflation pressure should be less than30MPa. Do not over-inflate your PCP air gun .
The duty cycle is : continuous inflation for 25minutes and rest for 10 minutes
If the temperature reachs 80 degrees , please stop filling and keep the fan running to dissipate heat
Tighten the bleed valve before inflation , loosen it after filling completion to release the high-pressure air in the hose , and then disconnect the air gun .
Always turn on the cooling fan first and turn off last . Keep the cooling fan running until the compressor cools below 50C
Packing list:
1 x high pressure air pump
1 x 110V to 12V External Power Adapter (The input voltage has been set to 110v and the portsare connected to wires . All left to do is simply inserting .)
1 x 12V car battery charger
1 x Oil water separator
1 x manual instructions
- We maintain high standards of excellence and strive for hundred percent customer satisfaction. Feedback is very important to us. We hope that you contact us immediately before you give neutral or negative feedback, so that we can address your concerns. It is impossible to address issues if we do not know about them!
On Jul 1, 2025 at 20:08:25 PDT, seller added the following information: