|
|
|
|
|
|
|
|
Brand NEW Blower Motor For Car
Features:
- NEW, not remanufacturedor rebuilt
- DIRECT REPLACEMENT
- Built to strict quality control standards
- HIGH QUALITY - Top quality materials which provide maximum strength and durability
- 1 YEAR WARRANTY-This item is backed by a 1 Year Warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge (excludes shipping charges) for the original purchaser.
- 100% tested prior to leaving the factory
- The blower motor can be installed easily with no special tools required and just by removing a few screws under the passenger side dash of your vehicle. Simply remove the old blower motor and put the new one in. It is also a advisable to replace your blower motor relay/resistor with a new one when you replace your blower motor.
What Are Signs Your Blower Motor Needs to Be Replaced?
- Poor or Airflow from Air Vents
- No Airflow At All From Vents
- Skyrocketing Energy Bills
- Strange Noises When You Turn on the Heat
- Overheating Blower / Weird Smells
Fitting for the following years and models:
- 2009-2011 Ford Flex
- 2008-2012 Ford Taurus
- 2008-2009 Ford Taurus X
- 2009-2012 Lincoln MKS
- 2010-2011 Lincoln MKT
- 2008-2009 Mercury Sable
- 2008-2012 Ford Taurus
Removing the Blower Motor
Step 1
Disconnect the ground cable from the negative battery terminal. Loosen the retaining bolt using a wrench. Pull the clamp off the terminal.
Step 2
Locate the blower motor. On most vehicles, it will be located inside the engine bay along the firewall on the passenger side of the vehicle. On some vehicles, it may be located inside the passenger compartment, below the dash on the passenger side of the vehicle.
Step 3
Pull the wiring connector or connectors off the blower motor, using your hand. In most cases there will be one plastic connector. If there are more than one, use masking tape and a marker to label them for reassembly,
Step 4
Using a socket, unscrew the screws that secure the blower motor to the heater case or firewall.
Step 5
Pull the blower motor and fan blades from the vehicle as an assembly.
Step 6
Unscrew the nut that secures the fan blades to the motor, using a socket.
Step 7
Pull the fan blades away from the motor.
Installing the Blower Motor
Step 1
Drop the fan blades into position on the new motor.
Step 2
Screw on the nut that secures the fan blades to the motor.
Step 3
Slide the motor/fan blade assembly into position in the heater case or firewall.
Step 4
Screw in the screws that secure the blower motor to the heater case or firewall.
Step 5
Press the plastic wiring connector onto the back of the blower motor.
Step 6
Reconnect the ground cable to the negative battery terminal. Slide the clamp over the terminal and tighten the retaining bolt with a wrench.
Step 7
Test for proper operation.
NOTE:
- Please compare your parts against pictures to ensure this part fits your vehicle
- Please confirm your old part number matches up with one of the part numbers above
- Professional installation is highly recommended (No Instruction Included)
- For any needs please contact us.
Brand NEW Blower Motor For Car
Features:
- NEW, not remanufacturedor rebuilt
- DIRECT REPLACEMENT
- Built to strict quality control standards
- HIGH QUALITY - Top quality materials which provide maximum strength and durability
- 1 YEAR WARRANTY-This item is backed by a 1 Year Warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge (excludes shipping charges) for the original purchaser.
- 100% tested prior to leaving the factory
- The blower motor can be installed easily with no special tools required and just by removing a few screws under the passenger side dash of your vehicle. Simply remove the old blower motor and put the new one in. It is also a advisable to replace your blower motor relay/resistor with a new one when you replace your blower motor.
What Are Signs Your Blower Motor Needs to Be Replaced?
- Poor or Airflow from Air Vents
- No Airflow At All From Vents
- Skyrocketing Energy Bills
- Strange Noises When You Turn on the Heat
- Overheating Blower / Weird Smells
Fitting for the following years and models:
- 2009-2011 Ford Flex
- 2008-2012 Ford Taurus
- 2008-2009 Ford Taurus X
- 2009-2012 Lincoln MKS
- 2010-2011 Lincoln MKT
- 2008-2009 Mercury Sable
- 2008-2012 Ford Taurus
Removing the Blower Motor
Step 1
Disconnect the ground cable from the negative battery terminal. Loosen the retaining bolt using a wrench. Pull the clamp off the terminal.
Step 2
Locate the blower motor. On most vehicles, it will be located inside the engine bay along the firewall on the passenger side of the vehicle. On some vehicles, it may be located inside the passenger compartment, below the dash on the passenger side of the vehicle.
Step 3
Pull the wiring connector or connectors off the blower motor, using your hand. In most cases there will be one plastic connector. If there are more than one, use masking tape and a marker to label them for reassembly,
Step 4
Using a socket, unscrew the screws that secure the blower motor to the heater case or firewall.
Step 5
Pull the blower motor and fan blades from the vehicle as an assembly.
Step 6
Unscrew the nut that secures the fan blades to the motor, using a socket.
Step 7
Pull the fan blades away from the motor.
Installing the Blower Motor
Step 1
Drop the fan blades into position on the new motor.
Step 2
Screw on the nut that secures the fan blades to the motor.
Step 3
Slide the motor/fan blade assembly into position in the heater case or firewall.
Step 4
Screw in the screws that secure the blower motor to the heater case or firewall.
Step 5
Press the plastic wiring connector onto the back of the blower motor.
Step 6
Reconnect the ground cable to the negative battery terminal. Slide the clamp over the terminal and tighten the retaining bolt with a wrench.
Step 7
Test for proper operation.
NOTE:
- Please compare your parts against pictures to ensure this part fits your vehicle
- Please confirm your old part number matches up with one of the part numbers above
- Professional installation is highly recommended (No Instruction Included)
- For any needs please contact us.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
1. Package handling takes about 2 business days at our warehouse, so please make sure entering correct payment and shipping information before checking out. Once your payment is completed, we are not going to accept any more changes to your order.
2.All domestic orders will be shipped via USPS, UPS or Fedex from our US warehouse and usually arrives to your door in about 2-7 business days.
3.Local pick up is not available.
4.International Buyers C Please Note:
a. Import duties, taxes and charges are not included in the item price or shipping charges. These charges are the buyers responsibility.
b. Please check with your country customs office to determine what these additional costs will be prior to bidding/buying. ]
[We only accept payment through PayPal. You can open a Paypal account at www.paypal.com.]
1.All of our brand new items come with a 60-Days money-back guarantee.
2.We define the item as defective only if it doesn't function as described, It is the buyer's responsibility to understand the item description before bidding.
3.We will replace the defective items, provided that they are in stock within the warranty period posted with the listing and the buyer return the original item and pay for the S&H cost for the replacement.
4.We will refund the purchase price if the replacement is not available or buyer prefers a refund and send the original item back at his/her own cost.
5.Shipping& handling cost are not refundable.
6.Man-made damage by abuse or wrong operation is not covered by this warranty.
7.No product liability insurance is assumed.
8.Refunds will be credited within 5 to 7 business days of receiving the return. When we've received and processed the return, we will refund the applicable amount minus any Recovery Fees (See Details Below) for the amount you paid for the item(s), plus any applicable sales tax. ]
Q: How do I pay for my purchase?
A: MY store accepts PayPal.
Q: When will the item be shipped out?
A: This item will be shipped with 2 business day once payment completed.