5V Relay Module with Optocoupler Low Level Trigger Expansion Board for Arduino – Single Channel
These relays work
great, genuine work horses, with SMD optocoupler isolation, and very stable
performance.
It
can be used as a microcontroller development board module, or as home appliance
control.
Normally open interface
and can be set to high or low triggered by jumper.
Maximum load: AC
250V/10A, DC 30V/10A.
Trigger current: 5mA
Fail safe design,
even if the control line is broken, the relay will not operate.
Convenient terminal
wiring leads, easy to connect and operate
5V relay module
TTL
control signal of 5V-12V
Controls
DC or AC signal, and controls 110V or 220V AC load.
There
is a normally open and a normally closed contact
With
power indicator
The
control pin has a pull-down circuit to prevent floating relay from
malfunctioning
Specs:
·
Optocoupler isolation, good anti-interference
·
Low level pull-in, high-level release. Pull, the
status LED ON. Release, status LED OFF
·
VCC for the system power, JD_VCC for the relay
power
·
Board around with four fixed screw holes, hole
diameter 3.1mm, easy to install and fixed
·
Maximum load: AC
250V/10A, DC 30V/10A
·
Trigger current: 5mA
·
Dimensions (2 channels): 50.5mm * 38.5mm * 18.5mm
·
Weight (2 channels): 31g
·
Dimensions (1 channel): 43mm * 21mm * 14mm
·
Weight (1 channel): 22g
*** CHECK OUR
EBAY STORE FOR OTHER GREAT DEALS!! **