|
Dental Curing Light
Parameter：
Wavelength：440-480nm
Light power：5W
Intensity：800-1400mw/cm²
Battery：Li-on 800mAh
Input voltage：AC100-240V, 50/60Hz 0.4A Max
Output voltage：DC 5V/1.5A
Net Weight：155g
Mode selection：P1, P2, P3
Solidification time：1S,3S,5S,10S,15S,20S
Features:
·Produce the maximum light intensity safely.
· A high intensity of 1400 mW/cm2.
· Offers extremely short curing times of no
more than 3 seconds.
· Cordless, highly portable and light weight
(only 155g).
· High-performance Li-ion battery
technology.
· LED panel conveniently indicates a
countdown curing time.
· Battery can be fully recharged in 90
minutes.
· Battery with protection against
over-voltage, over-current and short circuit.
· 3 versatile curing modes for every indications.
· Automatic power off, low battery alert.
· Color : White .
Operation
conditions:
1. Storage
Condition: Temperature: +10℃+40℃
2. Humidity:
30%-75%
3. Atmospheric
pressure: 70KPa-106Kpa
4. Environment
Conditions: Not near from fire equipment or flammability material.
//////////////////////////////////////////////////
Denterx etching gel is a polymer thickened gel for use on enamel and dentin.
This gel will effectively treat enamel and dentin, producing the necessary microretentive surface for successful bonding. The polymer thickener creates thixotropic properties, enhancing handling characteristics. The etchant rinse away cleanly and quickly, leaving no residue.
Packages: Refill: 5 ml/syringe, Instruction X1
Indications:Treat dentin and enamel, Treating agent on dental restorative material.
1. Isolate tooth and then prepare the cavity in a conservative manner. clean the entire surface with a slurry of pumice and water.
2. Apply etchant using a tip, a disposable syringe tip, or disposable brush tip. allow etchant to remain in palce for 15 seconds. etching time should be monitored with a stopwatch. begin timing at the end of application.
Option: place etchant enamel first, then proceed to cover dentin, for a slightly longer enamel etching time.
3. Rinse thoroughly (at least 5 seconds) to completely remover all traces of etchant.
4. Remove exces moisture from the tooth and proceed with the applicaton of etching gel, waiting for 10 seconds, then rise thoroughly. then apply adhesive
Packing
list:
The host
* 1
Metal lamp holder *1
The silicone base
*1
Power adapter
*1
Disposable protective sleeve *1
Shade plate
*1
Product specification *1
FDA Statement
The sale of this item may be subject to
regulation by the U.S. Food and Drug Administration and state and local
regulatory agencies. If so, you can bid
on this item only if you are an authorized purchaser. If the item is subject to
FDA regulation, I will verify your
status as an authorized purchaser of this item before shipping of the
item.
Seller name:Dentalbest
City,State:SHENZHEN,China
Telephone number:0755-23991254
| 
