Directions:
1. Check the piece to make sure it is the exact fit for
your vehicle. Determine the location of where the piece will be going.
2. Make sure that you have washed and dried the surface on which the trim will
go.
3. Remove any left-over adhesive on the vehicle. (Preferred method is a
credit card and WD-40) Please be
very careful and fragile on the paint, we are not responsible for any scratches or defects on the car.
4. Use a solvent to remove any left-over
adhesive, oils, or wax. (It will
affect the stickiness)
5. Use a clean cloth and alcohol to remove any
solvent. Wash down with water, and dry with a clean microfiber towel.
6. Apply adhesive promoter to
the surface which the trim will be applied to and the back side of
the trim to where the double-sided tape will be mounted on.
7. Apply the exact amount of double sided tape
to the trim. Make sure that your
palms are dry, avoid wet and sweaty hands.
8. Use the palm of your hand, and a firm
pressure to mount the emblem down.
9. Keep your car in a dry and warm area for the
tape to stick on properly for at least 24 hours. Over time it'll be
mounted down very firmly.