Installation Guide Video For Clip Replacement https://www.youtube.com/watch?v=0TXNWY8cILo
Removal of Latch Housing From Seat Video https://youtube.com/shorts/njqxg-HktBU?feature=share
Designed and produced by myself proudly in Pennsylvania USA, Thank you for supporting small businesses.
Center clips ONLY, as that is the factory part that breaks leaving your housing with pin and spring intact to reuse.
This is a replacement clip ONLY set of 2 for the second row seat latch
that is commonly broken across GMT800 SUV's. This latch prevents the
second row seat panel attached to the rear of the seat from falling into
the floor, preventing anyone from sitting comfortably in the third row
seats.
3D printed in ASA for exceptional strength and heat resistance,
surpassing the OEM latch. This is just the center latch that commonly
breaks, you will reuse your original housing with pin and spring.
To install simply remove the latch assembly from the rear seat by
depressing both clips inward with thin flat head screw drivers or a
pick. Then push the pin out of the original latch housing making note of
which way the spring was seated. Install the new clip in reverse by
partially inserting the pin through the thicker side until it protrudes
slight out of where the spring will sit. Using a pair of needle nose
pliers, position the spring in line with the pin and push the pin fully
through the other side.
This includes all NBS 2000-2006 Tahoe, Suburban(1500 or 2500), Yukon, Yukon XL (1500 or 2500)
2001-2006 Yukon Denali & Yukon XL Denali
2002-2006 Escalade & Escalade ESV
You will receive a clip for each side for a total of 2
Installation Guide Video For Clip Replacement https://www.youtube.com/watch?v=0TXNWY8cILo
Removal of Latch Housing From Seat Video https://youtube.com/shorts/njqxg-HktBU?feature=share